clucth pedal goes to the floor as in no pressure

[bimmerrob10]

thinking i blew the slave cyl weird i just drove all over lastnight with np at all then this morning nothing, clutch has onlt about 6k miles so its not that

[Eleventeen11]

can you pull your pedal back up and it work again? if so i too have this problem and it typicaly just need to be bled.

[bimmerrob10]

it comes back up on its own just no pressure when i go to ingage it to put it in gear

unless the clutch master cylinder blew

[jmo69]

When I did my CDV delete and hadn't properly bled it, the pedal didn't return. I think your master is bad. Just my $.02

[bimmerrob10]

checked the master no leaks at all , when i pulled the slave out it was soaked i depressed the slave rod no resistance at all and it made air sounds when i depressed it so im thinkin the seal went in the slave, i have no idea what a cdv delete is lol

[PHARMDVIPER]

common problem....get a new slave and you should be good to go

[bimmerrob10]

cool i got the slave today 85 bucks ... now the damn pressure line is rusted like hell on there .... sprayed the hell out of it 3 times gunna let it sit overnight and try again tomm with luck ill b mobile again lol

slaves just go like that overnight ? kinda weird......but i did notice my brake fluid is a bit low .. maybe it sucked air into the line guess ill c when i install the slave tomm

[jmo69]

Yeah those lines can be a PITA in salt country. You might have to hold the hard line and turn the slave to get it apart. When I did my CDV (clutch delay valve) delete I had to use my torch to get things apart. BTW your car doesn't have the CDV.

[bimmerrob10]

yeah its lookin like ill have to turn the slave i have a propane torch also , worked on my o2 sensor.. torch that is lol . ive had sticks almost my whole life and never seen a pedal do that in 35 yrs lol ......(18 drivin and workin on cars ) weird

[orangehatter]

An 11mm flare wrench helps greatly in getting the clutch line off.

[bimmerrob10]

used it its still not moving lol ... ready to take it off at the joint hose located on the underside of the firewall and get a whole new hose if it doesnt come off tomm ...

[orangehatter]

Just pick up a stainless clutch line. If your line is corroded that bad, I'm sure the rubber is probably rotted too, so a new line would help greatly.

[bimmerrob10]

i just looked for a new line found one on ecs website... dont feel like waiting for shipping maybe ill try around here mon , if tomm fails hose looked good i checked it for cracks and stuff mabe the part that goes to the slave took alot more weathering . either way deff gettin a new hose