97mreaper
08-26-2010, 02:11 AM
ok just recently installed used aa c38 kit now i was having problems with boost leaks n ect but got all that fixed and she pulled hard. then all of a sudden i go to do another pull and the car is spitting and sputtering so i pull over and the car shuts off. i start it back up shuts off again so i start it and rev it to keep the engine running and limp back to the garage. i check all my lines ect everything is good then i unplug the maf sensor and wala it starts and stays idling but i go to take it for a spin and it doesnt even feel like it has a supercharger on it just feels like a n/a car? so my question is how do i check if my maf is bad or the scalar provided with the kit is? and would i lose that much power from unplugging the maf or should i start looking else where?