Would these Brembo 6 piston calipers fit?

[Dr320i]

I had a chance to purchase two big brake kits from a factory closing in Europe. They had been powdercoated yellow but are brand new. After shipping, duty, etc it turn out that only one correct set of calipers was sent. The second set were much, much bigger.:D

They are 6-piston radial mount calipers with staggered pistons. The piston sizes are on each side:

- 34.7mm (x2)
- 44.2mm (x1)

The mounting holes are at 210mm for the radial mount. They fit up to 34mm thick rotors.

Since they were in the wrong packaging I can't identify them. I do know that they are much to big for my E21 project.

Any ideas?

http://70.38.66.123/b4/847/446725/1279892294-637.JPGhttp://70.38.66.123/b4/847/446725/1279892287-771.JPGhttp://70.38.66.123/b4/847/446725/1279892309-755.JPGhttp://70.38.66.123/b4/847/446725/1279892318-521.JPGhttp://70.38.66.123/b4/847/446725/1279892364-291.JPGhttp://70.38.66.123/b4/847/446725/1279892377-929.JPGhttp://70.38.66.123/b4/847/446725/1279892349-272.JPG