WTB: 328i/is/ic DRIVESHAFT FROM MANUAL TRANSMISSION

[orangehatter]

Looking for a driveshaft from a ZF 320 manual transmission 328i/is/ic or M3. Must have under 150k miles, no bends, and a good U-joint. Needs to have a four bolt flange at the rear. Not really concerned about the condition of the center support bearing as I already have a new one ready to be installed. Need this for my Getrag 250 to ZF 320 swap!

Will entertain any offers.

:redspot

[NASA144]

not sure if it will work...
have a 95 m3 shaft, 6-bolt at rear dif flange, needs new csb. lol
pm if interested

[orangehatter]

Replied and original post updated.