Cleaning sude seats?

[1flossedm3]

Hi guys,

I have a customer with a 05 terminator that I've done a full paint restore on.

Any ideas how i can clean suede? Will the little Bissell steam cleaner do the trick?

Thanks

Ryan

[TOGWT]

Foam Cleaner (N-Nubuck / Alcantara® and Perforated leather ) is a solvent free pump action product, which is extremely efficient for the cleaning of general soiling and water based stains on Nubuck, brushed aniline suede and perforated leathers. Always pre-test the product on a hidden area. This cleaner is an aerosol version of Leather Master™ Strong Cleaner.
The advantage of foam over liquid is the minimum amount of moisture, very important for cleaning absorbent materials. Clean the surface with a Leather Master™ cleaning pad, or use the foam cleaner. The foam created by this aerosol has the consistency of shaving cream, making it ideal for sensitive leather.
Do not allow to dry as it can leave spot marks. For heavily soiled areas, or where the leather has become ingrained such as in creases in the leather, a soft brush can be used to agitate and loosen the dirt.
These steps may be all you need to clean these surface but if it still appears stained, you can try adding a small amount of white vinegar to a soft washcloth and gently buff the surface.
Be sure to do your patch test first. For rally stubborn stains; clean the surface with 303™ Cleaner & Spot Remover (do not saturate) it removes oil, grease, ink, berry juice, wine and blood. It contains no soaps, detergents, phosphates, nitrates, caustics, toxic organics, enzymes or volatile organic chemicals (VOC)
Using a soft upholstery brush (Swissor a Rubber Suede Brush) to raise the `nap' of the surface then apply cleaner by spraying onto a 100% cotton towel (do not saturate) allow to air dry. The surface of these leathers has no protective barrier, and as a result these leathers are very prone to soiling and staining. To protect unfinished leathers including deerskin and unfinished dyed leathers, use Leather Master™ Nubuck Protection
Methodology
• Shake well before use
• Spray a small amount of the product no more than 12 inches from the leather's surface.
• Use a sponge to work the foam into the soiled area, as it acts as a cushion, preventing too much pressure.
• Gently wipe away excess foam, and allow to dry for 30 minutes.
• Repeat for extremely soiled areas.
• Once the area is clean, apply a Nubuck Protectant to prevent future soiling