2010 black Hyundai Genesis - swirled, etched and oxidized!

[Matt@Autogeek]

This is a 2010 Hyundai Genesis with (I think) 15k miles on it. I'm assuming it sits under a sprinkler often, because the whole car had bad water etching all over it, and some light oxidation. Swirling was pretty average, but pretty deep in some areas. The front passenger side was repainted recently and had some very deep swirls and sanding tracers, which the Cyan pad wasn't touching. For these, I switched to a Surbuf R pad with M105, and it cut way faster than the Cyan, although it did not leave as nice of a finish. I also used the Surbuf pads on some of the deeper etching and swirls on the car.

The paint on this car was VERY hard, similar to a C5/C6 Corvette. M105 on a Cyan pad took care of most defects and actually left a pretty nice finish. M205 with a gray pad was icing on the cake, and Fuzion made the paint look like a black pool of water.

Wash:
-Pinnacle Bodywork Shampoo (http://autogeek.net/pinbodsham.html)
-Lake Country wash sponges (http://www.autogeek.net/car-wash-sponge.html)
-Two-bucket method w/ Grit guards (http://www.autogeek.net/grit-guard.html)
-P21S Wheel Cleaner Gel (http://www.autogeek.net/p2wheelclean.html)
-Short Handle Tire/Wheel Brush (http://www.autogeek.net/tiwhbr.html)
-Daytona Speedmaster Wheel Brush (http://www.autogeek.net/ezdebrfca.html)
-Clean Wheel Lug Nut Brush (http://www.autogeek.net/lug-nut-brush.html)

Clay:
-DP Universal Detailing Clay (http://www.autogeek.net/dp720.html)
-DP Universal Clay Lubricant (http://www.autogeek.net/dp365.html)

Paint Correction:
-Flex XC3401VRG Dual Action Polisher (http://www.autogeek.net/flex-orbital-polisher.html)
-Meguiar's #105 Ultra Cut Compound (http://www.autogeek.net/meguiars-mirror-glaze-105-ultra-cut-compound.html) with Lake Country Cyan 6.5" Hydro Tech pads (http://www.autogeek.net/lc-hydro-tech-foam-pads.html) and Surbuf R series pads
-Meguiar's #205 Ultra Finishing Polish (http://www.autogeek.net/meguiars-finishing-polish.html) with Lake Country Flat 6.5" Gray Finishing Pads (http://www.autogeek.net/vcpad.html)
-Grit Guard Pad Washer (http://www.autogeek.net/grit-guard-universal-pad-washer.html)
-Menzerna Top Inspection (http://www.autogeek.net/menzerna-top-inspection.html)
-3M Automotive Performance Masking Tape (http://www.autogeek.net/3m-auto-masking-tapes.html)
-IPA

LSP:
-Wolfgang Fuzion Carnauba Polymer Estate Wax (http://www.autogeek.net/wolfgang-fuzion-carnauba-polymer-car-wax.html)
-Meguiar's Last Touch Detailer (http://www.autogeek.net/meguiar-s-last-touch-spray.html)

Tires, trim, etc:
-303 Aerospace Protectant (http://www.autogeek.net/303aerprot.html) on trim
-Optimum Opti-Bond Tire Gel (http://www.autogeek.net/optimum-opti-bond-tire-gel-32oz.html) on tires
-Menzerna Polishing Cream (http://www.autogeek.net/menzerna-polishing-cream.html) on exhaust tips


Some "before" shots:
http://www.autogeekonline.net/gallery/data/840/IMG_0943.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0944.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0945.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0946.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0947.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0948.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0949.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0950.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0958.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0957.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0959.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0960.jpg


Claying:

http://www.autogeekonline.net/gallery/data/840/IMG_09641.jpg


As you can see, clay didn't really touch the water etching.

http://www.autogeekonline.net/gallery/data/840/IMG_09681.jpg


IPA after polishing:

http://www.autogeekonline.net/gallery/data/840/IMG_0974.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0976.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0986.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0990.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0991.jpg


Here's what my clay looked like after doing an entire panel.

http://www.autogeekonline.net/gallery/data/840/IMG_0993.jpg

[Matt@Autogeek]

Unpolished / polished (trunk only, spoiler was not touched yet)

http://www.autogeekonline.net/gallery/data/840/IMG_0999.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_0998.jpg


Fuzion applied

http://www.autogeekonline.net/gallery/data/840/IMG_1001.jpg


"After" shots.

http://www.autogeekonline.net/gallery/data/840/IMG_1002.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1004.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1005.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1006.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1008.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1011.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1013.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1015.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1016.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1018.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1020.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1023.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1022.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1024.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1025.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1026.jpg

http://www.autogeekonline.net/gallery/data/840/IMG_1028.jpg

Thanks for looking!

[Koobie]

Awesome looking car. Great work!!

[Bishop_325i]

15k miles and it's a 2010 model? Jesus.... turn around is pretty nice looking... Looks pretty abused for being so new.

[shellback]

purpose of IPA?

[Matt@Autogeek]

purpose of IPA?

This removes polishing oils, which can hide certain defects. Wiping the area a few times with IPA will reveal the true condition of the paint. ;)

[tman1299]

nice job. I love that car.

[sullysdetailing]

Great Job Matt

[e24mpwr]

purpose of IPA?

I just did a quick writeup here (http://forums.bimmerforums.com/forum/showthread.php?t=1413376).

[Palo De Leva]

Matt,

Great turnaround! That is also the first Genesis I have seen detailed ;) Props on the great work!

[Matt@Autogeek]

Thanks guys! :)