Another Check your Brake Linings error

[ktmdrz400]

Changed brakes and rotors and replaced both sensors. Went through the process of reprogramming and also disconnected the battery (http://forums.bimmerforums.com/forum/showthread.php?t=64164#). The check brake linings is still on.????? I dsiconected and reconnected the sensors also. Could it be I have a bad sensor??, or should I do something else???, or worst case take it to the dealer to have them reset??

[jamesdc4]

Turn key to position 2 (don't start the car) for approximately thirty seconds.
Turn key to position 0 and it should clear the error message.
Post the results back here!

[ktmdrz400]

Tried it again, a few times. Still no worky:confused

[jamesdc4]

When I had my brakes done, it took a day or two for the error message to go away.
The method posted above has been used by other members successfully, so I'm not sure what's up.

[sjohnson1776]

Worked like a champ in my E39! Thanks!!!!!

[jstern]

Turn key to position 2 (don't start the car) for approximately thirty seconds.
Turn key to position 0 and it should clear the error message.
Post the results back here!

+1

That's the way to do it as per James and the Bentley Manual.