M5 Clutch Line [Archive] - Bimmerforums

M5W

01-20-2009, 05:12 AM

Does the clutch line from a 540 fit an M5 ?

David325e

01-20-2009, 05:25 AM

not sure what you mean by clutch line. If its a metal line then the flanges could be different sizes, the bends in the lines could be different, or the length could be different

MacR

01-20-2009, 08:55 AM

The line from the master to slave cylinder? No. Threads are wrong, most likely the bends are as well.

M5W

01-20-2009, 01:55 PM

The reason i say this is because the master is listed the same on the M5 and the 540i. MACR are you for certain that the threads are different ? If the threads on the master are the same it leads me to believe they would be the same on the hard lines as well. Just cause right now the rubber line going to the slave is really flexing alot and soft and i wanna put in the UUC line for the 540 cause a new stock rubber line is 100 bucks.