13124860_10209177849421198_87370318340368092_n.jpg13087752_10209177849581202_6746795723505374638_n.jpghey guys, i have installed an 18 button obc into my 1997 323i, the wiring for the obc display and the gong was there, 1 black and 1 white plug for the obc, 4 plugs for the gong, 1 black, 1 white and 2 smaller black and white plugs, all the buttons on the obc work and show accurate information, the gong seems to work as well, when i turn the car on it beeps, when i reverse it also beeps until i take it out of reverse, the check control function doesnt seem to work though, its shows as 'check control inact", iv look at the spot that the check control module is said to be in, under the drivers side dash, the 2 screws that hold it are there however i have'nt located any wiring for it, the photo attached is the only thing i could see that could potentially have something to do with it, there are all those wires going into that thing but no wires come out of it, like someone has pulled the wiring out on the top. any suggestions?