Cosmos 1995 BMW M3 Built Low Compression motor GT35R turbo- Car is located in San Francisco, and has always been garaged it whole life. Email me at James@superrewards.com or feel free to call with any questions. (858)2485918
I had initially posted for a quick sale but decided to get a garage and sit on it so that I can get more money back. Car was garaged for a long time by a friend that I sold it too and recently got it back. In all honesty its condition is not as good as nice as I sold it to him. The paint went from a 10 to about an 8. other than that everything seems fine.
One thing that is unique to this set up is that it has passed CA smog tests.. The car also has a CARB sticker. This 50 state CARB EO sticker will help immensely. All routine maintenance has been performed and the car is mechanically sound and rides on Tien SS’s with 18 inch black BBS RX’s. The chassis has 211k miles on it. Most these miles are highway due to the previous owners 70-mile roundtrip commute when th car was na. However all bushings drive shaft and diff were all replaced. The subframe was recently reinforced and has all new bushings. . The car is in great shape and the engine is fully built-ready for someone else to enjoy. It is a custom turbo kit, which uses TRM chip and is tuned off the cars stock ecu.
Motor and turbo have 8700 miles on it since its build. There is not much that can handle as well or is half as fast that you will encounter on the road. Car is a beast. Clutch has been replaced with a brand new Southbend stage 5.
I have the car set on 13.5 psi which makes roughly 432rwp and is plenty for the street, but the boost can safely be turned up. I have had alot of questions about the car. I tried to list everything done to it, but I am certain I am leaving stuff out. The specs are listed below and if you have any questions please let me know, thanks.
Asking 14k
858-248-5918
Body:
-Cosmos Black
-Black interior
-Vaders
-17% tint
-Upgraded 3 spoke steering wheel
Suspension:
-Tien SS
-RSM’s (Bimmerforum lifetime Warranty)
-Powerflex Rear Trailing Arm Bushings
-Subframe reinforced and Rear trailing arm pockets welded
-New Bushings for subframe and diff
-New steering rack and pump
-New rear wheel bearings
Exterior:
-DEPO 6k HID with Angle Eyes
-18" BBS RX's - Powdercoated w/Toyo T1R's front 95% tread, Rear 75% tread
-Stealth grills
Boost:
-Treadstone manifold -T3 with v band and gt 35 r turbo
-Tial44mm wastegate (.6 bar and 1 bar springs)
-Extreme Motorsports motor mount arm
-666 charge piping
-hks ssq bov (flange is on 666 piping)
-3" turbo back exhaust with magnaflow muffler and high flow cat.
Fuel:
-60 # injectors
-Whalbro upgraded fuel pump
Tuning:
-TRM W/ 413 Ecu
-803 3.5 hfm
Gauges: (in center cluster configuration includes Defi controller)
-AEM Uego wideband
-Defi Boost
-Defi Oil Temp [/COLOR]
-HKS Boost Controller ver. 6
-Southbend after market clutch holds 600rwtq
Engine:
Bottom end:
-wiseco pistons 8.8:1
-ARP main studs
-ARP headstuds
-.080 vac mls headgasket
Head:
-vac dual valve springs
-vac hardened steel retainers
-new OE bmw valve collets
-new OE bmw guides
-new OE bmw valve stem seals
-new OE bmw oil squirters
-full new gasket for the block and head
-new ngk bkr7e plugs
-new timing chain tensioner(upper) and new guides
-3 angle valve job
-head resurfaced to 20 ra(very good sealing surface)
-Dr Vanos Vanos Unit
Let me know if you have any questions.
Last edited by alpinem3///; 02-22-2015 at 02:20 PM.
Pics?
[http://i152.photobucket.com/albums/s...cc/bbk013.jpg]
- - - Updated - - -
Big brake kit is gone back to stock now
Pics look like a stock bottom end with an MLS, is that correct?
No Pistons and arp main and head studs - it's in the description.
There's a video that Cam (Highbostingm3) made a while back. I will find the link and post it. Also have a bunch of pics if you want to email me: James@superRewards.com !
Just sent you an email to get some more pics...
Could you elaborate on the motor in terms of who built it? Also do you have interior pictures? The ones in the album just show the seats and door cards on the ground.
Thanks,
David at 4b auto put it together I put it in.
ready to let the car go for 14k. Email me for pics please
Email me for pics-sold the BBK will let the car go for 12.5k!
Moderators can you please change title and remove the 10k price point. I do not want to confuse anyone, thanks.
OLD
E30
636whp
1/4 mile: 10.91@144.38
http://www.youtube.com/watch?v=L_f7fUVqblI
NEW BUILD
335d
520whp
635wtq
120.51mph trap speed
I would have to agree with you. Even at 12.5k its a pretty good deal for a fully sorted car with subframe and trailing pockets reinforced as well as a built motor with a 35R. Plus all the defi gauges and the CARB sticker. If I did not get a garage I would have sold it super cheap and for 10k, but I know the car is worth a lot more than that.
I guess I am just going to have to wait till someone comes along and realizes the value of the car and understand how much it would cost to replicate it. If I did not have a Porsche turbo with upgraded turbos I would never consider getting rid of the car!
Pm sent!
I just emailed you. Still for sale?
Sale is pending right now - I never received an email BigMitch, unless you are Jay.
Yes. I am Jay
Bookmarks